Posted on Leave a comment

Changing the Bolts in your Barwa

Last week I had two more Barwa Chairs delivered and much like our original one, the bolts were completely rusted. Replacing these is not a requirement to enjoy a new cover, but at a certain point we recommended to replace them. Not only is rust gross to look at, but flakes can fall off and stain the area near by. Trust me, rust is not your friend.

Continue reading Changing the Bolts in your Barwa
Posted on Leave a comment

How to Polish a Barwa Frame

Specifically how Amanda went from “don’t bring that in the house” to “we should put the Barwa in our living room!”

A new cover and set of springs will go a long way in maintaining your Barwa chair’s use and beauty, but properly polishing the frame can make it look almost new. This post will walk through the method we used to polish our Barwa frame with just a few inexpensive supplies, some elbow grease, and patience. Our goal with this process is to bring your frame to its full potential, not necessarily remove every single scratch, ding, or imperfection on the frame. I found that bringing the metal to a nice shine helps hide some of the imperfections, and they’re only visible upon very close inspection. Depending on the specific condition of your frame, you may find that courser sanding grit is required for certain parts. Use your judgment and feel free to diverge from what’s recommended here based on your situation. If perfection is what you’re after maybe consider looking into having the legs chromed just as Edgar Bartolucci, one of the designers of the Barwa, did on his own personal chairs. Also, please leave comments if you have suggestions for alternative methods or other improvements that would be helpful to others.

Continue reading How to Polish a Barwa Frame